Septic Pump Not Working

If your septic tank will not begin there are three primary areas to examine for any issues The electronic system of the pump along with the pump's controls.

Electricity is extremely risky Be aware while working in the field of electricity. Also, switch off power supply breakers for testing the components of an electrical circuit. If you're not certain that you are able to perform any of these tests in a safe manner contact an expert.

Electrical issues

If the pump doesn't appear to be operating in any way, doesn't respond to any tests , and isn't pumping effluent it could be due to an issue with the wiring. Check the circuit breaker and then use an instrument like a multimeter to inspect the wiring in the system to find out what needs to be replaced.

A fuse has been blown or a the circuit breaker has been activated. Examine fuses and circuit breakers. Replace fuses as necessary. Take note of the recommended size by the pump's manufacturer and the nameplate of the pump. Contact an electrician to fix the circuit in case it is needed.

The power cord of the pump is not wired properly and is not making good contact. If the system has an auxiliary plug-in, examine the prongs of the cap for the pump for corrosion and tightness. Install the new plug and scrub the prongs of the connector with abrasive papers, or replace the electrical receptacle.

The branch circuit is too small to support this pump's load. Make sure the line voltage is checked and compare it to manufacturer's specifications. The pump must be connected into its circuit breaker (or fuse). In the event that the circuit breaker is feeding electricity to other appliances or outlets then, install an outlet to allow the pump to have its own circuit breaker. Contact an electrician to fix the circuit.

The motor overload of the pump tripped. Let the pump cool for five to ten minutes, then reconnect it. If the overload occurs again then take the corrective action. Check the voltage of the line and then compare it with specifications of the manufacturer. A professional electrician or the power company examine the voltage of the branch circuit. The pump should be connected to an independent branch circuit.